MCDS with mounting plate

The stainless steel double door combinable floor
standing enclosure range, MCDS, is ideal for installation
in confined spaces where a single door, when opened,
would take up too much space in front of the enclosure.
The doors’ loading capacity also increases as it is
divided over two doors. With a IP 55 protection degree,
components inside the enclosure are well protected and
makes it well suited for almost any environment, grade
dependent.
Material: AISI 304L pre-grained stainless steel / AISI 316L. Frame: 1.5
mm. Door: 2 mm. Rear, roof and side panels: 1.5 mm. Bottom plates:
1.5 mm stainless steel. Mounting plate: 3 mm galvanized steel.
Frame: Seam welded reversed open profiles with 25
mm hole pattern, according to DIN 43660.
Door: Mounted with four hinges. Including door frame with
25 mm hole pattern. Doors cannot be reversed. Separate
doors to be ordered for left hand door locking.
Rear panel: Fitted by M6 torx screws. Standard facilities for rear
door mounting. Split rear panels in 1600 mm wide enclosures.
Side panels: Supplied as an accessory.
Roof panel: Removable.
Lock: Espagnolette 4-point locking system in the main door
and 2-point locking system in the slave door. Standard doublebit
lock with 3 mm insert. Standard inserts, cylinders, lift
handles and T-handle are available as accessories.
Bottom plates: Two piece bottom plate in 1200 mm width, with
injected polyurethane gasket to ensure maximum sealing.
Mounting plate: Double folded and adjustable in depth by
steps of 25 mm, with the MPD02 accessory. Mounting plate is
delivered, attached on the outside of the enclosure packaging.
Earthing: All panels are earthed through their fittings
and are equipped with a separate earthing stud.
Finish: 400 pre-grained stainless steel.
Protection: Complies with IP 55 | TYPE 12 | IK 10.
Mounting requirements: Standard delivery ready for combined
installation. For stand-alone installation, add side panels.